Sdc S6100 SERIES REVERSIBLE PANIC/FIRE EXIT Manuale Utente Scaricare il pdf (Pagina 7)

P:\INSTALLATION INST\Mechanical Hardware\INST-S6200.vsd Rev - 01-11 Page 3

STEP 1: PREPARE DOOR

1. Mark position of holes on the door per template (see figure 1).

2. Drill all holes marked on the door for the device chassis and top and bottom latch mounting

brackets.

3. Mortise hole for outside trim is required.

NOTE; Any hole drilled from the outside, first needs a pilot hole drilled from the inside

to ensure good alignment.

Figure 1

2-7/16”

Mark Backset

JAMB

2-5/16"

3-7/32"

INSIDE FACE OF DOOR

1016mm

(40")

Mark of device

3-7/32"

1-15/32"

1/4”

of top and bottom latches

Surface of the door must be

flush. Clear away any raised

jutting to allow the exit device to

rest on flat surface of the door.

40" to finished floor

Standard centerline height of device is 40" above the finished floor.

Prepare door for your specific

device per supplied template.

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Nessun commento

Sdc S6100 SERIES REVERSIBLE PANIC/FIRE EXIT Manuale Utente Pagina 7